Wednesday, November 6, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Technical Service Bulletin # 09-08-50-011A Date: 110413

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Technical Service Bulletin # 09-08-50-011A Date: 110413

Body - Sticking/Binding Door Mounted Seat Switches

TECHNICAL

Bulletin No.: 09-08-50-011A

Date: April 13, 2011

Subject: Sticking/Binding Door Mounted Seat Switches (Align Switch)

Models:

2007-2012 Cadillac Escalade, Escalade ESV, Escalade EXT

2007-2012 Chevrolet Avalanche, Silverado, Suburban, Tahoe

2007-2012 GMC Sierra, Yukon, Yukon Denali, Yukon XL, Yukon XL Denali

All Equipped with RPOs AN3, KA1, KB6

Supercede:

This bulletin is being revised to add model years. Please discard Corporate Bulletin Number 09-08-50-011 (Section 08 - Body and Accessories).

Condition

Some customers may comment that the door mounted memory/ heated/ cool seat switch buttons are sticking or binding.

Cause

This condition may be caused by the switch being out of alignment in the bezel, creating a hard contact between the switch button and the inside

release handle bezel.

Correction

1. Remove the door trim. Refer to Front Side Door Trim Panel Replacement in SI.

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 182

2. Loosen both screws (1) holding the switch to the inside release handle bezel.

3. Using a flat-bladed tool (1), carefully shift the position of the switch to create a nominal gap all around its perimeter within the bezel. Tighten

the two screws holding the switch.

4. Confirm that the switch buttons are free moving, and there is a nominal gap (1) all around its perimeter within the bezel.

5. Reinstall the door trim. Refer to Front Side Door Trim Panel Replacement in SI.

Warranty Information

For vehicles repaired under warranty, use the table.

No comments:

Post a Comment