2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 698
DTC B2880 01
- Tilt Position Sensor Circuit Short to Battery
DTC B2880 06
- Tilt Position Sensor Circuit Short to Ground or Open
DTC B2880 5A
- Tilt Position Sensor Circuit Plausibility Failure
DTC B2880 61
- Tilt Position Sensor Actuator Stuck
Diagnostic Fault Information
Circuit Description
The memory seat module (MSM) determines the position of the steering column based on inputs received from the tilt position sensors built into
the tilt actuators. The MSM supplies a 5-volt reference and a low reference to the sensors and monitors the column position via the steering column
tilt sensor signal circuit.
Conditions for Running the DTC
Ignition ON
Conditions for Setting the DTC
B2880 01
The steering column tilt sensor signal voltage is greater than 4.8 volts for more than 2 seconds.
B2880 06
The steering column tilt sensor signal voltage is less than 0.2 volt for more than 2 seconds.
B2880 5A
An incorrect steering column tilt sensor signal voltage is seen.
B2880 61
The steering column tilt sensor signal voltage does not change when the tilt actuator is commanded.
Action Taken When the DTC Sets
Steering column tilt operations are suspended.
Conditions for Clearing the DTC
* A current DTC will clear when the malfunction is no longer present
* A history DTC will clear after 50 malfunction-free ignition cycles.
Reference Information
Schematic Reference
Steering Wheel Schematics (See: Diagrams/Electrical Diagrams/Steering/Steering Column/Steering Wheel Schematics)
Connector End View Reference
No comments:
Post a Comment