The measurement value is OK.Cause
- Control module has an internal error.
REMEDY
- Disassemble and assemble automatic transmission using the repair instructions.
- Exchange electrohydraulic control unit.
IMPORTANT NOTEFollowing the repair measures, the following checks MUST be carried out using the Diagnosis Assistance System, menu
'Control unit adaptations'
- Flash programming of control unit Y3/8n4 (Fully integrated transmission control (VGS) control unit)
- SCN coding
End of test
NO
The measurement value is not OK.Possible cause and remedy
- Diagnostic cable has short to ground.
- Inspect wiring and connectors at connection points for loose contacts, damage and corrosion. Repair or replace as required.
End of test
NO
The measurement value is not OK.Possible cause and remedy
- Diagnostic cable has open circuit.
- Inspect wiring and connectors at connection points for loose contacts, damage and corrosion. Repair or replace as required.
End of test
NO
The measurement value is not OK.Further causes
- Voltage supply line is not OK.
Press button "F2" for further tests
1.1.3.2.1.13. No further information available.
1.1.3.2.2. Resistance test of engine compartment CAN
Test 1.1.3.2.2.1: Test total resistance of engine compartment CAN.
Test 1.1.3.2.2.2: Test terminating resistor of component X30/5 (Left voltage distributor (CAN) connector).
Test 1.1.3.2.2.3: Test terminating resistor of CAN element in control module N3/10 (ME-SFI [ME] control unit).
1.1.3.2.2.1. Test total resistance of engine compartment CAN.
Test 1.1.3.2.2.1.1: Perform measurement at component N3/10 (ME-SFI [ME] control unit).
Test 1.1.3.2.2.1.2: Perform measurement at component X30/5 (Left voltage distributor (CAN) connector).
1.1.3.2.2.1.1. Perform measurement at component N3/10 (ME-SFI [ME] control unit).
Test total resistance of the CAN engine.
Test sequence
- Switch off ignition.
- Connect socket box to component N3/10 (ME-SFI [ME] control unit).
- Measure resistance with multimeter between sockets (F.41) 11 and (F.54) 24 of the 35-pole socket box tester.
Specified value
- Resistor[55...65]ohms
Question
- Is the measurement value OK?
YES
The measurement value is OK.End of test
No comments:
Post a Comment