2010 Cadillac Truck SRX FWD V6-3.0L Page 1532
DTC P0503
- Vehicle Speed Sensor Circuit Intermittent
Circuit/System Description
The transmission control module (TCM) provides the engine control module (ECM) vehicle speed information through the high-speed
communication on the controller area network (CAN). Vehicle speed is produced by the alternating current (AC) generated through the
transmission output shaft speed (OSS) sensor as the output shaft rotates. The ECM continuously monitors the vehicle speed signal supplied by the
TCM.
Conditions for Running the DTC
* Engine coolant temperature is more than 39.8掳C (104掳F).
* No engine coolant temperature DTC is set.
* No engine speed sensor DTC is set.
* The DTCs run continuously once the above condition is met.
Conditions for Setting the DTC
P0501
The ECM detects the CAN signal is not valid for more than 2 s.
P0503
The ECM detects the vehicle speed is greater than 275 km/h (171 MPH) for more than 0.2 s.
Action Taken When the DTC Sets
* DTC P0501 is a Type C DTC.
* DTC P0503 is a Type B DTC.
Conditions for Clearing the DTC
* DTC P0501 is a Type C DTC.
* DTC P0503 is a Type B DTC.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams/Electrical
Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Description and Operation
Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/AF40-6 - Automatic Transmission/Transmission Component and System Description)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
No comments:
Post a Comment