2010 Cadillac Truck SRX FWD V6-3.0L Page 1997

2010 Cadillac Truck SRX FWD V6-3.0L Page 1997

P2176

DTC P1516, P2101, P2119, or P2176 (LF1, LFW)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P1516

- Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance

DTC P2101

- Throttle Actuator Position Performance

DTC P2119

- Throttle Closed Position Performance

DTC P2176

- Minimum Throttle Position Not Learned

Diagnostic Fault Information

Circuit/System Description

The engine control module (ECM) controls the throttle valve by applying a varying voltage to the control circuits of the throttle actuator control

(TAC) motor. The ECM monitors the duty cycle that is required to actuate the throttle valve. The ECM monitors the throttle position (TP) sensors 1

and 2 to determine the actual throttle valve position.

Conditions for Running the DTC

P1516

* The ignition voltage is greater than 6 V and reduced power is not active.

* The engine is running.

* DTCs P1516 runs continuously when the above conditions are met.

P2101

* DTC P1682 not set.

* The engine is running.

* The ECM has learned the minimum throttle position.

* The ignition voltage is greater than 6 V and reduced power is not active.

* DTCs P2101 run continuously when the above conditions are met.

P2119

* DTCs P0121, P0122, P0123, P0222, P0223, P0641, P0651, P0697, P06A3, or P2135 are not set.

* The ignition is ON.

* The ignition voltage is greater than 6 V.

* DTC P2119 runs continuously when the above conditions are met.

P2176

* DTCs P0068, P0122, P0123, P0222, P0223 are not set.

* The ignition is ON.

* The ignition voltage is greater than 6 V and reduced power is not active.

* DTC P2176 runs continuously when the above conditions are met.