2010 Cadillac Truck SRX FWD V6-3.0L Page 1462

2010 Cadillac Truck SRX FWD V6-3.0L Page 1462

crankshaft position sensor, and the camshaft position sensor for sequencing and timing of the spark events.

Conditions for Running the DTC

* The engine is running.

* The ignition voltage is greater than 6 V.

* DTC P0351-P0356 runs continuously when the above conditions are met.

Conditions for Setting the DTC

The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 5 s.

Action Taken When the DTC Sets

DTCs P0351-P0356 are Type B DTCs.

Conditions for Clearing the MIL/DTC

DTCs P0351-P0356 are Type B DTCs.

Diagnostic Aids

A high resistance condition on any ignition control circuit can cause an engine misfire without setting DTC P0351-P0356.

Reference Information

Schematic Reference

Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics

(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Electronic Ignition System Description (See: Powertrain Management/Computers and Control Systems/Description and Operation/Electronic

Ignition System Description)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Engine running, observe the following scan tool control circuit status parameters for the appropriate cylinder T8 ignition coil:

* Ignition Coil 1-6 Control Circuit Low Voltage Test Status

* Ignition Coil 1-6 Control Circuit Open Test Status

* Ignition Coil 1-6 Control Circuit High Voltage Test Status

Each parameter should display Not Run or OK.

2. Engine idling, observe the DTC information with a scan tool. DTC P0351, P0352, P0353, P0354, P0355, or P0356 should not set.

3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions that you observed from the Freeze Frame/Failure Records data.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the appropriate T8 ignition coil.

2. Ignition OFF, and all vehicle systems OFF, it may take up to 2 minutes for all the systems to power down. Test for less than 5 ohm between

the ground circuit terminal A and ground.