Wednesday, June 1, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1539

2010 Cadillac Truck SRX FWD V6-3.0L Page 1539



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Throttle Body Assembly Replacement (LF1) (See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and



Repair/Removal and Replacement)Throttle Body Assembly Replacement (LAU) (See: Powertrain Management/Fuel Delivery and Air



Induction/Throttle Body/Service and Repair/Removal and Replacement)



P0513



DTC P0513



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC P0513



- Immobilizer Key Incorrect



Circuit/System Description



The body control module (BCM) sends the pre-release information to the engine control module (ECM) via the serial data circuit. The ECM then



sends a challenge to the BCM. Both the ECM and BCM perform a calculation on this challenge. If the calculated response from the BCM equals



the calculation performed by the ECM, the ECM will allow vehicle starting.



Conditions for Running the DTC



Ignition is in the ACCESSORY or RUN position.



Conditions for Setting the DTC



The calculated response from the BCM does not equal the calculation performed by the ECM.



Action Taken When the DTC Sets



* The security indicator in the instrument cluster will illuminate.



* Vehicle starting will be disabled.



Conditions for Clearing the DTC



* A current DTC P0513 will be cleared when a valid calculation is received.



* A history DTC will be cleared after 40 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.



Diagnostic Aids



The key referenced in the DTC descriptor does not refer to the vehicle key. In this case, key is referring to the challenge response.



Reference Information



Schematic Reference



Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer



Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and



Operation/Immobilizer)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)

No comments:

Post a Comment