Friday, May 27, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 940

2010 Cadillac Truck SRX FWD V6-3.0L Page 940



* The TCM defaults the TCM power up temperature to the TCM substrate temperature.



Conditions for Clearing the DTC



DTC P06AC, P06AD, P06AE are Type B DTCs.



Reference Information



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



* Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/6T70/6T75 - Automatic Transmission/Transmission General Description)



* Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/6T70/6T75 - Automatic Transmission/Electronic Component Description) for control solenoid valve assembly



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Engine idling at normal operating temperature, verify the scan tool TCM Power up Temperature parameter is between -59 and +165掳C (-74



and +329掳F).



2. Operate the vehicle at 64 km/h (40 mph) for 10 minutes. Monitor the TCM Temperature, TCM Power up Temperature, and the Trans. Fluid



Temp. parameters with a scan tool. The TCM Temperature and the Trans. Fluid Temp. parameters should be within 20掳C (36掳F) of each



other, and the TCM Temperature and TCM Power up Temperature parameters should be within 10掳C (18掳F) of each other.



瀚慖f the TCM Temperature and TCM Power up Temperature parameters are not within 10掳C (18掳F), or the TCM Power up Temperature



and Trans. Fluid Temp. parameters are not within 20掳C (36掳F), replace the control solenoid valve assembly.



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Repair Instructions



Note:



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning) following all transmission related repairs



* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission



and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6T70/6T75 - Automatic



Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,



and programming



P06AD



DTC P06AC-P06AE



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment