Monday, May 16, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 950

2010 Cadillac Truck SRX FWD V6-3.0L Page 950



The ECM detects that the knock sensor signal circuits are shorted to ground for greater than 10 s.



P0328 and P0333



The ECM detects that the knock sensor signal circuits are shorted to voltage for greater than 10 s.



P06B6 and P06B7



The ECM has detected an internal knock sensor processor fault.



Action Taken When the DTC Sets



* DTCs P0324, P0325, P0326, P0327, P0328, P0330, P0331, P0332 P0333, P06B6, and P06B7 are Type B DTCs.



* The ignition timing is retarded to reduce the potential of engine damaging spark knock.



Conditions for Clearing the DTC



DTCs P0324, P0325, P0326, P0327, P0328, P0330, P0331, P0332 P0333, P06B6, and P06B7 are Type B DTCs.



Diagnostic Aids



* Inspect the knock sensor for physical damage. A knock sensor that is dropped or damaged may cause a DTC to set.



* Inspect the knock sensor for proper installation. A knock sensor that is loose or over torqued may cause a DTC to set. The knock sensor



should be free of thread sealant.



* The knock sensor mounting surface should be free of burrs, casting flash, and foreign material.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Electronic Ignition System Description (See: Powertrain Management/Computers and Control Systems/Description and Operation/Electronic



Ignition System Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Engine at operating temperature, all accessories OFF, and engine speed greater than 2,000 RPM, observe the Knock Retard and Total Knock



Retard parameters. The parameters should be 0掳.



2. Engine idling, move the related harnesses and connectors for the KS circuits while observing the scan tool Knock Retard and Total Knock



Retard parameters. The parameters should remain steady with no abrupt changes.



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Circuit/System Testing

No comments:

Post a Comment