Saturday, May 14, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1912

2010 Cadillac Truck SRX FWD V6-3.0L Page 1912



5. If all circuits test normal, test or replace the transmission shift lever.



Component Testing



1. Ignition OFF, disconnect the harness connector at the transmission control.



2. Test for 6.74-6.94 k ohms between terminals A and B.



瀚慖f not within the specified range, replace the transmission control.



3. Test for 1.77-1.97 k ohms between terminals A and B while pressing the upshift button.



瀚慖f not within the specified range, replace the transmission control



4. Test for 3.87-4.07 k ohms between terminals A and B while pressing the downshift button.



瀚慖f not within the specified range, replace the transmission control.



Repair Instructions



Important:



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning) following all transmission related repairs.



* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See:



Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General



Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Transmission Control Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and



Repair/6T70/6T75 - Automatic Transmission/Transmission Control Replacement) for AT TAP shift switch replacement.



* Control Module References (See: Testing and Inspection/Programming and Relearning) for body control module (BCM) or control solenoid



valve assembly replacement, setup, and programming



P1915



DTC P182E or P1915



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P182E



- Internal Mode Switch - Invalid Range



DTC P1915



- Internal Mode Switch Start/Wrong Range



Diagnostic Fault Information



Typical Scan Tool Data

No comments:

Post a Comment