2010 Cadillac Truck SRX FWD V6-3.0L Page 875

2010 Cadillac Truck SRX FWD V6-3.0L Page 875

DTC Descriptors

DTC C0870 03

- Control Module Voltage Reference Output Circuit Low Voltage

DTC C0870 07

- Control Module Voltage Reference Output Circuit High Voltage

Diagnostic Fault Information

Circuit/System Description

The suspension control module supplies a 5 V reference voltage and a low reference to each body acceleration sensor and vertical suspension

acceleration sensor. The body acceleration sensors and vertical suspension acceleration sensors supply a signal of 0.5-4.5 V to the suspension

control module.

Conditions for Running the DTC

System voltage is between 9-16 V.

Conditions for Setting the DTC

C0870 03

The suspension control module detected a short to ground on the 5 V reference circuit for 1.5 s.

C0870 07

The suspension control module detected a short to voltage on the 5 V reference circuit for 1.5 s.

Action Taken When the DTC Sets

* The electronic suspension control is disabled for the duration of the ignition cycle.

* The driver information center displays the SERVICE SUSPENSION SYSTEM message.

Conditions for Clearing the DTC

* A present DTC will clear on the next consecutive malfunction-free ignition cycle.

* A history DTC will clear after 41 consecutive malfunction-free ignition cycles.

Reference Information

Schematic Reference

Electronic Suspension Control Schematics (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic

)/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Electronic Suspension Control Description and Operation (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic

)/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)