Thursday, March 17, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 793

2010 Cadillac Truck SRX FWD V6-3.0L Page 793



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Brake Pedal Position Sensor Replacement ()



* Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup and



programming



C0186



DTC C0186, C0196, C019B, or C0287



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC C0186 5A



- Lateral Acceleration Sensor Circuit Not Plausible



DTC C0186 71



- Lateral Acceleration Sensor Circuit Invalid Data



DTC C0196 00



- Yaw Rate Circuit Malfunction



DTC C0196 5A



- Yaw Rate Signal Not Plausible



DTC C019B 5A



- Yaw Rate Signal Not Plausible



DTC C0287 4B



- Longitudinal Acceleration Sensor Circuit Calibration Not Learned



DTC C0287 5A



- Longitudinal Acceleration Sensor Circuit Not Plausible



DTC C0287 71



- Longitudinal Acceleration Sensor Circuit Invalid Data



Diagnostic Fault Information



Circuit/System Description



The yaw rate, lateral acceleration and longitudinal acceleration sensors are combined into one multi-axis acceleration sensor, external to the



electronic brake control module (EBCM). The EBCM supplies a 12 V reference voltage to the multi-axis acceleration sensor. The multi-axis



acceleration sensor communicates with the EBCM via the high speed controller area network (CAN) serial data circuit. The EBCM activates the



stability control function depending on multi-axis acceleration sensor input.



Conditions for Running the DTC

No comments:

Post a Comment