2010 Cadillac Truck SRX FWD V6-3.0L Page 918

2010 Cadillac Truck SRX FWD V6-3.0L Page 918

P00C6

The ECM detects that the fuel pressure is not rising or has fallen beyond acceptable limits during engine cranking.

P228C

The actual fuel rail pressure is 1.5 MPa (218 psi) less than the desired fuel pressure. The condition exists for greater than 5 s.

P228D

The actual fuel rail pressure is 3.6 MPa (522 psi) greater than the desired fuel rail pressure. The condition exists for greater than 5 s.

Action Taken When the DTC Sets

* DTCs P0089 and P00C6 are Type B DTCs.

* DTCs P228C and P228D are Type A DTCs.

* A message center or an indicator displays Reduced Engine Power.

Conditions for Clearing the DTC

* DTCs P0089 and P00C6 are Type B DTCs.

* DTCs P228C and P228D are Type A DTCs.

Diagnostic Aids

* A restricted fuel feed pipe between the fuel feed pipe fuel pressure sensor and the high pressure fuel pump may set a DTC.

* A condition with the fuel tank fuel pump module or fuel pump flow control module may set a DTC.

* A skewed fuel rail pressure sensor, or an intermittent condition in the fuel rail pressure sensor circuits may set a DTC.

* A leaking or restricted fuel injector may set a DTC.

* A short to voltage in the crankshaft position signal circuit may set a DTC.

* A short to voltage in the camshaft position actuator solenoid valve control circuit may set a DTC.

Reference Information

Schematic Reference

Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics

(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Fuel System Description (LF1) (See: Powertrain Management/Fuel Delivery and Air Induction/Description and Operation/Fuel System

Description)Fuel System Description (LAU or LY7) (See: Powertrain Management/Fuel Delivery and Air Induction/Description and

Operation/Fuel System Description)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Observe the DTC information with a scan tool. DTC P0627, P0628, P0629, P069E, or U0109 should not set.

瀚慖f a DTC is set refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble