Tuesday, March 29, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1533

2010 Cadillac Truck SRX FWD V6-3.0L Page 1533



1. Ignition On, observe the DTC information with a scan tool. Verify no TCM or communication DTCs are set.



瀚慖f any TCM or communication DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code



Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) for further diagnosis.



2. Raise the drive wheels.



Caution: Support the lower control arms in the normal horizontal position in order to avoid damage to the drive axles. Do not operate the



vehicle in gear with the wheels hanging down at full travel.



3. Support the lower control arms so that the drive axles are in a horizontal position.



4. Engine running, place the transmission into 2nd gear.



5. Observe the scan tool Vehicle Speed parameter. The following should display a similar vehicle speed once the drive wheels are at a speed



above 5 km/h (3 MPH):



* The scan tool Vehicle Speed parameter



* The odometer



6. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



瀚慖f the DTC resets, replace the ECM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* ECM or TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup and



programming.



* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).



P0503



DTC P0501 or P0503



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0501



- Vehicle Speed Sensor Performance



DTC P0503



- Vehicle Speed Sensor Circuit Intermittent



Circuit/System Description



The transmission control module (TCM) provides the engine control module (ECM) vehicle speed information through the high-speed



communication on the controller area network (CAN). Vehicle speed is produced by the alternating current (AC) generated through the



transmission output shaft speed (OSS) sensor as the output shaft rotates. The ECM continuously monitors the vehicle speed signal supplied by the



TCM.



Conditions for Running the DTC



* Engine coolant temperature is more than 39.8掳C (104掳F).



* No engine coolant temperature DTC is set.



* No engine speed sensor DTC is set.



* The DTCs run continuously once the above condition is met.



Conditions for Setting the DTC

No comments:

Post a Comment