Saturday, February 12, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 763

2010 Cadillac Truck SRX FWD V6-3.0L Page 763



Conditions for Running the DTC



Ignition OFF, ACCESSORY, or RUN mode.



Conditions for Setting the DTC



The parking brake control module has an internal counter which keeps track of dynamic applies. When the counter reaches the threshold value this



DTC will set.



Action Taken When the DTC Sets



A message and/or a warning indicator may be displayed.



Conditions for Clearing the DTC



* The parking brake control module clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



* Adjust or replace the park brake pads.



Reference Information



Schematic Reference



Park Brake System Schematics (See: Brakes and Traction Control/Parking Brake System/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Electronic Parking Brake Control Module Description (See: Brakes and Traction Control/Parking Brake System/Parking Brake Control



Module/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Verify DTC C028D is not set.



If DTC is set, replace the rear brake pads and perform the Parking Brake Calibration procedure.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for parking brake control module replacement, setup, and



programming.



C028F



DTC C028F



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

No comments:

Post a Comment