2010 Cadillac Truck SRX FWD V6-3.0L Page 944

2010 Cadillac Truck SRX FWD V6-3.0L Page 944

1. Engine idling at normal operating temperature, verify the scan tool TCM Power up Temperature parameter is between -59 and +165掳C (-74

and +329掳F).

2. Operate the vehicle at 64 km/h (40 mph) for 10 minutes. Monitor the TCM Temperature, TCM Power up Temperature, and the Trans. Fluid

Temp. parameters with a scan tool. The TCM Temperature and the Trans. Fluid Temp. parameters should be within 20掳C (36掳F) of each

other, and the TCM Temperature and TCM Power up Temperature parameters should be within 10掳C (18掳F) of each other.

瀚慖f the TCM Temperature and TCM Power up Temperature parameters are not within 10掳C (18掳F), or the TCM Power up Temperature

and Trans. Fluid Temp. parameters are not within 20掳C (36掳F), replace the control solenoid valve assembly.

3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions that you observed from the Freeze Frame/Failure Records data.

Repair Instructions

Note:

* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Programming and Relearning) following all transmission related repairs

* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission

and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6T70/6T75 - Automatic

Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,

and programming

P06A3

DTC P0641, P0651, P0697, or P06A3 (LF1)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0641

- 5 V Reference 1 Circuit

DTC P0651

- 5 V Reference 2 Circuit

DTC P0697

- 5 V Reference 3 Circuit

DTC P06A3

- 5 V Reference 4 Circuit

Circuit/System Description

The engine control module (ECM) has 4 5 V reference circuits. The ECM provides the 5 V reference to various sensors. Each reference circuit

provides a 5 V reference for more than one sensor. An open, short to ground, or short voltage on one of the 5 V reference circuits can affect all the

components connected to that 5 V reference circuit. The ECM monitors the voltage on the 5 V reference circuits.

Conditions for Running the DTC

DTCs P0641, P0651, P0697, P06A3 run continuously when the ignition is ON.

Conditions for Setting the DTC

The 5 V reference circuit voltage is greater or less than a predetermined threshold.

Action Taken When the DTC Sets