2010 Cadillac Truck SRX FWD V6-3.0L Page 861
* Steering Angle Sensor Replacement (See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and Switches -
Steering/Steering Angle Sensor/Service and Repair/Removal and Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning)for module replacement, setup and programming
C0720
DTC C0720
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC C0720 71
- Engine Torque Management Feedback Signal Invalid Data
Circuit/System Description
The suspension control module receives high speed controller area network (CAN) message inputs from the engine control module (ECM)
identifying the actual engine torque. The suspension control module utilizes this signal to control the vehicle ride characteristics.
Conditions for Running the DTC
System voltage is between 9-16 V
Conditions for Setting the DTC
The suspension control module received invalid serial data from the ECM.
Action Taken When the DTC Sets
The electronic suspension control is disabled for the duration of the ignition cycle.
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present.
* A history DTC will clear after 41 consecutive malfunction-free ignition cycles.
Reference Information
Schematic Reference
Electronic Suspension Control Schematics (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic
)/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Electronic Suspension Control Description and Operation (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic
)/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
No comments:
Post a Comment