2010 Cadillac Truck SRX FWD V6-3.0L Page 1792

2010 Cadillac Truck SRX FWD V6-3.0L Page 1792

* DTCs P0961 and P0963 are Type C DTCs.

* The TCM freezes transmission adaptive functions.

* The TCM commands maximum line pressure.

P0962

* DTC P0962 is a Type A DTC.

* The TCM defaults the transmission to reverse and 5th gear.

* The TCM inhibits the torque converter clutch (TCC).

* The TCM commands maximum line pressure.

* The TCM freezes transmission adaptive functions.

* The TCM turns the high side driver OFF.

* The TCM inhibits Tap Up/Down function.

* The TCM inhibits manual shifting of forward gears.

* The TCM enables torque management.

Conditions for Clearing the DIC/DTC

* DTCs P0961 and P0963 are Type C DTCs.

* DTC P0962 is a Type A DTC.

Reference Information

Connector End View Reference

* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)

Description and Operation

Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -

Automatic Transmission/Transmission General Description)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Special Tools

DT-47825-20 Adapter Harness

Circuit/System Verification

1. Engine running in Park position. Move the gear shifter lever into each gear position and back into Park position. Verify with a scan tool the

following test status parameters display OK:

* Line PC Sol. Perf. Test Status

* Line PC Sol. Ckt. High Voltage Test Status

* Line PC Sol. Ckt. Low Voltage Test Status

2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions that you observed from the Freeze Frame/Failure Records data.

Circuit/System Testing

Note: You must perform the Circuit/System Verification first.

1. Ignition OFF, remove the control solenoid valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly

Replacement (See: Powertrain Management/Transmission Control Systems/Actuators and Solenoids - Transmission and