Friday, December 3, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 1389

2010 Cadillac Truck SRX FWD V6-3.0L Page 1389



Action Taken When the DTC Sets



* DTCs P0300-P0306 are Type B DTCs.



* The ECM disables the fuel injector of the misfiring cylinder when a misfire is present.



Conditions for Clearing the DTC



DTCs P0300-P0306 are Type B DTCs.



Diagnostic Aids



* A misfire DTC could be caused by an excessive vibration from sources other than the engine. Inspect for the following possible sources:



- A tire or wheel that is out of round or out of balance



- Variable thickness brake rotors



- An unbalanced drive shaft



- Certain rough road conditions



- Transmission operation



- A damaged accessory drive component or belt; remove the belt and safely operate the engine to evaluate



* High resistance in the circuits of the injectors may set a misfire DTC without setting an injector DTC. Test the injector circuits of the affected



cylinder(s) for a high resistance if you suspect a condition.



* If the condition is intermittent, observing the scan tool IC Circuit Test and Fuel Injector Circuit Test Status parameters may help isolate the



condition. The circuit test status parameters will change from OK or Not Run to Fault if a condition exists.



* A condition in the heated O2 sensor (HO2S) heater control circuits may set a DTC P0300.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Special Tools



* J 26792 - Spark Tester



* For equivalent regional tools, refer to Special Tools (See: Powertrain Management/Computers and Control Systems/Tools and Equipment).



Circuit/System Verification



1. Engine idling at the normal operating temperature, there should be no abnormal engine noise.



瀚慖f there is an abnormal engine noise, refer to Symptoms - Engine Mechanical (See: Engine, Cooling and Exhaust/Engine/Testing and



Inspection/Symptom Related Diagnostic Procedures/Symptoms - Engine Mechanical).



2. Verify that no other DTCs are set.



瀚慖f a DTC is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble



Code (DTC) List - Vehicle).

No comments:

Post a Comment