2010 Cadillac Truck SRX FWD V6-3.0L Page 1248

2010 Cadillac Truck SRX FWD V6-3.0L Page 1248

* The air induction system and the air intake ducts for leaks, or for a missing air filter element

* A cracked EVAP canister

* Evaporative pipes obstructed or leaking

* The crankcase ventilation system for leaks

P0172 or P0175

* A mass air flow (MAF) sensor signal that is skewed-If the Short Term FT parameters for both banks changes greater than 20 % when the

MAF sensor is disconnected, refer to DTC P0101 (LAU) (See: P Code Charts/P0101)DTC P0101 (LF1) (See: P Code Charts/P0101).

* Fuel contamination-Refer to Alcohol/Contaminants-in-Fuel Diagnosis (Special Tool) (See: Powertrain Management/Fuel Delivery and

Air Induction/Fuel/Testing and Inspection/Alcohol/Contaminants-in-Fuel Diagnosis (Special Tool))Alcohol/Contaminants-in-Fuel

Diagnosis (Without Special Tool) (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Component

Tests and General Diagnostics/Alcohol/Contaminants-in-Fuel Diagnosis (Without Special Tool)).

* Missing, restricted, or leaking exhaust components-Refer to Symptoms - Engine Exhaust (See: Engine, Cooling and Exhaust/Exhaust

System/Testing and Inspection/Symptoms - Engine Exhaust).

* Malfunctioning fuel injectors-Refer to Fuel Injector Solenoid Coil Test (LAU) (See: Powertrain Management/Fuel Delivery and Air

Induction/Fuel Injector/Testing and Inspection)Fuel Injector Solenoid Coil Test (LF1, LFW) (See: Powertrain Management/Fuel

Delivery and Air Induction/Fuel Injector/Testing and Inspection) ,

* The air intake duct for being collapsed or restricted

* The air filter for being dirty or restricted

* Objects blocking the throttle body

* The evaporative emissions control system for improper operation

* Excessive fuel in the crankcase-Change the oil as necessary.

5. If all conditions test normal, test the engine for a mechanical condition. Refer to Symptoms - Engine Mechanical (See: Engine, Cooling and

Exhaust/Engine/Testing and Inspection/Symptom Related Diagnostic Procedures/Symptoms - Engine Mechanical).

6. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions that you observed from the Freeze Frame/Failure Records data.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

P182E

DTC P182E or P1915

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P182E

- Internal Mode Switch - Invalid Range

DTC P1915

- Internal Mode Switch Start/Wrong Range

Diagnostic Fault Information

Typical Scan Tool Data