2010 Cadillac Truck SRX FWD V6-3.0L Page 1969

2010 Cadillac Truck SRX FWD V6-3.0L Page 1969

* DTC P06A3 or P0697 are not set.

* The ignition is ON or the engine is operating.

* The ignition voltage is greater than 6 volts.

* The ECM is not commanding reduced power.

* The DTCs run continuously when the above conditions are met.

P2138

* DTCs P06A3, P0697, P2122, P2123, P2127, or P2128 are not set.

* The ignition is ON or the engine is operating.

* The ignition voltage is greater than 6 volts.

* The ECM is not commanding reduced power.

* The DTC runs continuously when the above conditions are met.

Conditions for Setting the DTC

P2122

The ECM detects that the APP sensor 1 voltage is less than 0.46 volt for less than 1 s.

P2123

The ECM detects that the APP sensor 1 voltage is greater than 4.7 volts for less than 1 s.

P2127

The ECM detects that the APP sensor 2 voltage is less than 0.32 volt for less than 1 s.

P2128

The ECM detects that the APP sensor 2 voltage is greater than 2.6 volts for less than 1 s.

P2138

The ECM detects that APP sensor 1 and APP sensor 2 disagree greater than 10 percent for less than 1 s.

OR

The ECM detects that both APP sensor 1 and APP sensor 2 are 5 percent greater than the learned minimum position for less than 1 s.

Action Taken When the DTC Sets

* DTCs P2122, P2123, P2127, P2128, and P2138 are Type A DTCs.

* The ECM commands the TAC system to operate in a Reduced Engine Power mode.

Conditions for Clearing the DTC

DTCs P2122, P2123, P2127, P2128, and P2138 are Type A DTCs.

Diagnostic Aids

* If a shared 5-volt reference circuit is shorted to ground or shorted to a voltage, other 5-volt reference circuits may be affected.

* The scan tool 5 volt reference parameter should display between 4.8-5.2 volts.

* A high resistance condition on the accelerator pedal position circuits could cause a DTC to set.

Reference Information

Schematic Reference

Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics

(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Throttle Actuator Control (TAC) System Description (See: Powertrain Management/Computers and Control Systems/Description and

Operation/Throttle Actuator Control (TAC) System Description)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)