Friday, November 19, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 1115

2010 Cadillac Truck SRX FWD V6-3.0L Page 1115



瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.



8. Ignition OFF, connect the red lead of the J 38522 to the signal circuit terminal A at the B75B MAF/IAT sensor harness connector. Connect



the battery voltage supply to the B+, and the black lead to ground.



9. Set the J 38522 signal switch to 5 V, the Frequency switch to 5K, and the Duty Cycle switch to Normal.



10. Ignition ON, observe the scan tool MAF Sensor parameter. The scan tool MAF Sensor parameter should be between 4,950-5,050 Hz.



瀚慖f the MAF Sensor parameter is not within the specified range, replace the K20 ECM.



11. If all other circuits test normal, test or replace the B75B MAF/IAT sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.



* Engine Coolant Temperature Sensor Replacement (LF1) (See: Engine, Cooling and Exhaust/Cooling System/Engine - Coolant Temperature



Sensor/Switch/Coolant Temperature Sensor/Switch (For Computer)/Service and Repair)Engine Coolant Temperature Sensor Replacement



(LAU) (See: Engine, Cooling and Exhaust/Cooling System/Engine - Coolant Temperature Sensor/Switch/Coolant Temperature



Sensor/Switch (For Computer)/Service and Repair)



* Mass Airflow Sensor with Intake Air Temperature Sensor Replacement (LF1) (See: Powertrain Management/Computers and Control



Systems/Air Temperature Sensor ( Ambient / Intake )/Service and Repair)Mass Airflow Sensor with Intake Air Temperature Sensor



Replacement (LAU) (See: Powertrain Management/Computers and Control Systems/Air Temperature Sensor ( Ambient / Intake )/Service



and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming



P0102



DTC P0102 or P0103 (LF1)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0102



- Mass Air Flow (MAF) Sensor Circuit Low Frequency



DTC P0103



- Mass Air Flow (MAF) Sensor Circuit High Frequency



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



The mass air flow (MAF) sensor is integrated with the intake air temperature (IAT) sensor. The MAF sensor is an air flow meter that measures the

No comments:

Post a Comment