2010 Cadillac Truck SRX FWD V6-3.0L Page 810

2010 Cadillac Truck SRX FWD V6-3.0L Page 810

The BCM detects a short to ground on the cruise/ETC/TCC brake signal circuit.

Action Taken When the DTC Sets

The cruise control system is disabled

Conditions for Clearing the DTC

* The DTC will be current for as long as the fault is present.

* When the fault is no longer present, the DTC will be a history DTC.

* A history DTC will clear after 50 ignition cycles.

Reference Information

Schematic Reference

Cruise Control Schematics (See: Cruise Control/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the X1 (LF1) or X2 (LAU) harness connector at the K20 ECM.

2. Connect a test lamp between the signal circuit terminal listed below and ground:

* Terminal 57 (LF1)

* Terminal 52 (LAU)

3. Ignition ON, observe the function of the test lamp while pressing and releasing the brake pedal. The test lamp should turn ON when the brake

pedal is pressed and turn OFF when the brake pedal is released.

瀚慖f the test lamp is always ON, test the signal circuit for a short to voltage.

瀚慖f the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance.

4. If all circuits test normal, replace the K9 BCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming

C0298

DTC C0298

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an