Thursday, November 25, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 1592

2010 Cadillac Truck SRX FWD V6-3.0L Page 1592



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Engine running for at least 1 minute.



2. Ignition OFF for 30 seconds.



3. Ignition ON, verify that DTC P0602 is not set.



瀚慖f the DTC is set, program the transmission control module (TCM). If the DTC resets, replace the control solenoid (w/body and TCM)



valve assembly.



4. Observe the DTC information with a scan tool. DTCs P0601, P0603, P0604, and P062F should not set.



瀚慖f a DTC sets, replace the control solenoid (w/body and TCM) valve assembly.



5. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Repair Instructions



Important: Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning) any time a transmission related component is serviced.



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid (w/body and TCM) valve assembly



replacement, setup, and programming



AF40-6 - Automatic Transmission



DTC P0601, P0602, P0603, or P0604



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0601



- Control Module Read Only Memory Performance



DTC P0602



- Control Module Not Programmed



DTC P0603



- Control Module Long Term Memory Reset



DTC P0604



- Control Module Random Access Memory Performance



Circuit/System Description



This is an internal fault detection of the transmission control module (TCM). This fault is handled inside the TCM and no external circuits are



involved.



Conditions for Running the DTC



The TCM runs the program to detect an internal condition at key ON. The only requirements are voltage and ground. This program runs even if the



voltage is out of the valid operating range.

No comments:

Post a Comment