Thursday, October 28, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 2170

2010 Cadillac Truck SRX FWD V6-3.0L Page 2170



Data Communication Schematics (See: Powertrain Management/Computers and Control Systems/Information Bus/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Data Link Communications Description and Operation (See: Powertrain Management/Computers and Control Systems/Information



Bus/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool References



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Verify the appropriate DTC is not set.



If the DTC is set, program the control module specified by the DTC descriptor. If the DTC resets, replace the control module specified by the DTC



descriptor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup, and programming



U0315



DTC U0300-U0336



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC U0301 00



- Software Incompatibility with Engine Control Module



DTC U0302 00



- Software Incompatibility with Transmission Control Module



DTC U0315 00



- Software Incompatibility with Electronic Brake Control Module



Circuit/System Description



Some control modules must be configured with specific software, serial numbers, vehicle options, or other information. If a control module was not



properly configured after installation that module may set the appropriate U Code. No external circuit diagnosis is involved.



Conditions for Running the DTC



Battery voltage is between 9-16 V and data link communications operate normally.

No comments:

Post a Comment