Friday, October 1, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 161

2010 Cadillac Truck SRX FWD V6-3.0L Page 161



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Replace the S3 Automatic Transmission Shift Lever and verify that the DTC does not reset.



If the DTC resets, replace the K9 Body Control Module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Automatic Transmission Range Selector Lever Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shift



Linkage/Service and Repair) for MXE



* Automatic Transmission Range Selector Lever Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter



A/T/Service and Repair/6T70/6T75 - Automatic Transmission/Automatic Transmission Range Selector Lever Replacement) for MH2, MH4



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming



B0074



DTC B0074



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B0074 00



- Passenger Presence Sensor Circuit Malfunction



DTC B0074 04



- Passenger Presence Sensor Open



Circuit/System Description



The passenger presence module monitors the sensor status continually. Whenever the sensor mat has an internal malfunction, the passenger



presence module will set DTC B0074.



Conditions for Running the DTC



Ignition voltage is between 9-16 V.



Conditions for Setting the DTC



B0074 00



The passenger presence module has detected a disconnection from the sensor mat.



B0074 04



The passenger presence module has detected an open circuit.

No comments:

Post a Comment