Tuesday, September 14, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 307

2010 Cadillac Truck SRX FWD V6-3.0L Page 307



The headlamp switch is supplied with ground at all times. When the headlamp switch is placed in either the park or low beam position, ground is



applied to the tail lamp signal circuit to the body control module (BCM). The BCM responds by applying battery voltage to the left/right park



lamps, left/right side marker lamps and left/right tail lamps. This energizes the appropriate lamp.



Conditions for Running the DTC



* The engine is running.



* Headlamp switch in AUTO position.



* The ambient light is day.



Conditions for Setting the DTC



B260B 01 or B260C 01



The BCM detects a short to voltage on the daytime running lamp relay control circuit.



B260B 02 or B260C 02



The BCM detects a short to ground on the daytime running lamp relay control circuit.



B260B 04 or B260C 04



The BCM detects an open/high resistance on the daytime running lamp relay control circuit.



Action Taken When the DTC Sets



B260B 01 or B260C 01



The appropriate daytime running lamp will be continuously illuminated.



B260B 02, B260C 04, B260B 02 or B260C 04



The appropriate daytime running lamp will be inoperative.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles.



Reference Information



Schematic Reference



Exterior Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Exterior Lights Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)



Circuit/System Verification



Ignition ON, command the Left Dedicated Daytime Running Lamp and the Right Dedicated Daytime Running Lamp ON and OFF with a scan tool.



The E4C daytime running lamp - left and the E4D daytime running lamp - right should turn ON and OFF while changing between the commanded

No comments:

Post a Comment