Sunday, September 19, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 238

2010 Cadillac Truck SRX FWD V6-3.0L Page 238



If the DTC is set, replace the appropriate K96L left mirror control module or the S79P passenger window switch.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning)for left mirror control module or passenger window switch



replacement, setup, and programming



B0158



DTC B0158



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B0158 02



- Ambient Air Temperature Sensor Circuit Short to Ground



DTC B0158 05



- Ambient Air Temperature Sensor Circuit High Voltage/Open



Diagnostic Fault Information



Circuit/System Description



The instrument cluster provides the ambient air temperature sensor with a low reference circuit and 5 V signal circuit. The instrument cluster



monitors the voltage drop across the sensor, which is proportional to temperature. When the ambient air temperatures are cold, the resistance of the



sensor is high and the voltage signals are high. When the ambient air temperatures are hot, the resistance of the sensors is low and the voltage



signals are low. The instrument cluster converts the voltage value to a temperature value of Celsius or Fahrenheit that will be displayed by the



driver information center.



Conditions for Running the DTC



The system voltage is between 9-16 V



Conditions for Setting the DTC



B0158 02



The instrument cluster detects the sensor signal circuit is greater than 88掳C (190掳F).



B0158 05



The instrument cluster detects the sensor signal circuit is less than -40掳C (-40掳F).



Action Taken When the DTC Sets



The instrument cluster uses a default air temperature value for further calculations. The driver information center displays ---掳C ( ---掳F).



Conditions for Clearing the DTC



The DTC will become history if the instrument cluster no longer detects a malfunction.

No comments:

Post a Comment