Sunday, September 26, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 428

2010 Cadillac Truck SRX FWD V6-3.0L Page 428



Control Module References (See: Testing and Inspection/Programming and Relearning) for liftgate control module replacement, setup and



programming



Supplemental Inflatable Restraints



DTC B1019



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B1019 00



- System Configuration Error



Circuit/System Description



The inflatable restraint sensing and diagnostic module (SDM) monitors the number of safety components installed on the vehicle. When the



ignition is turned ON, the SDM evaluates the number of safety components installed and compares it to the number of components the SDM



expects to see on the vehicle with its current calibration. If there is a mismatch between detected components and the components programmed with



the SDM calibration, DTC B1019 will set. The components (if equipped) that the SDM will detect include inflatable restraint deployment loops,



impact sensors, passenger presence system components, seat position sensors, disable switches, and seat belt switches.



Conditions for Running the DTC



Ignition voltage is between 9-16 V.



Conditions for Setting the DTC



The setup for the SDM has not been completed and the SDM does not detect the correct number of sensors or deployment loops than is expected



with this calibration.



Action Taken When the DTC Sets



* The SDM requests the instrument cluster to illuminate the AIR BAG warning indicator.



* The DTC must be cleared before running the setup SDM.



* Air bag indicator will continue to flash until SDM setup procedure is complete.



Conditions for Clearing the DTC



* The condition for setting the DTC is no longer present.



* A history DTC will clear once 100 malfunction-free ignition cycles have occurred.



Diagnostic Aids



The SDM scan tool deployment loop and impact sensor data will match what the SDM has been programmed to expect to see on the vehicle. B1019



DTC will set if a deployment loop or impact sensor is added or removed from the system.



DTC B1019 will set when an open/high resistance DTC sets for a deployment loop or impact sensor. This causes mismatch between the learned and



actual components connected to the SDM.



DTC B1019 can set with no other DTCs if an unused deployment loop or impact sensor circuit is shorted to ground. This causes a mismatch



between the learned and actual components connected to the SDM.



Reference Information



Schematic Reference



* Seat Belt Schematics (See: Diagrams/Electrical Diagrams/Seat Belt Systems)



* SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)



Connector End View Reference

No comments:

Post a Comment