Friday, September 17, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1624

2010 Cadillac Truck SRX AWD V6-3.0L Page 1624



- Fuel Pump Enable Circuit Low Voltage



DTC P0629



- Fuel Pump Enable Circuit High Voltage



Diagnostic Fault Information



Circuit/System Description



The engine control module (ECM) provides ignition voltage to the fuel pump flow control module whenever the engine is cranking or running. The



control module enables the fuel pump flow control module as long as the engine is cranking or running, and ignition system reference pulses are



received. While this enable voltage is being received, the fuel pump flow control module supplies a varying voltage to the in-tank fuel pump



module in order to maintain the desired fuel line pressure.



Conditions for Running the DTC



* The engine speed is greater than 0 RPM.



* The ignition voltage is between 11-18 V.



* The DTCs run continuously when the conditions above are met.



Conditions for Setting the DTC



* The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match.



* The above condition is met for a minimum of 2.5 s.



Action Taken When the DTC Sets



DTCs P0627, P0628, and P0629 are Type B DTCs.



Conditions for Clearing the DTC



DTCs P0627, P0628, and P0629 are Type B DTCs.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Attempt to start the engine. Observe the DTC information with a scan tool. DTC P0627, P0628, or P0629 should not set.



2. Ignition ON, command the ECM Fuel Pump Enable ON and OFF with a scan tool while observing the following control circuit status

No comments:

Post a Comment