Monday, September 13, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 2108

2010 Cadillac Truck SRX AWD V6-3.0L Page 2108



The TCM detects an incorrect on-coming clutch gear ratio, or flare, when the 1-2-3-4 clutch is commanded ON and the transmission input speed is



200 RPM or greater from the anticipated input shaft speed for 3.5 seconds, a total of 2 times in any one range that the 1-2-3-4 clutch is commanded



on.



P2724



The TCM detects an incorrect off-going clutch gear ratio, or tie-up, when the 1-2-3-4 clutch is commanded OFF and the transmission input speed is



40 RPM or less from the anticipated input shaft speed for 1.2 seconds, a total of 5 times.



Action Taken When the DTC Sets



P2723



* DTC P2723 is a Type A DTC.



* The TCM freezes transmission adaptive functions.



* The TCM commands maximum line pressure.



* The TCM inhibits Tap Up/Down function.



* The TCM inhibits manual shifting of forward gears.



* The TCM defaults the transmission to fifth range.



P2724



* DTC P2724 is a Type A DTC.



* The TCM freezes transmission adaptive functions.



* The TCM commands maximum line pressure.



* The TCM inhibits Tap Up/Down function.



* The TCM inhibits manual shifting of forward gears.



* The TCM limits the transmission to first, third or reverse operation.



Conditions for Clearing the DIC/DTC



DTCs P2723 and P2724 are Type A DTCs.



Diagnostic Aids



Before performing a road test, configure and setup the scan tool for snapshot mode. This will allow you to display, monitor, and verify multiple



transmission data parameters at one time, after the road test.



Reference Information



Connector End View Reference



* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)



Description and Operation



Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -



Automatic Transmission/Transmission General Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Note: If other DTCs are set, diagnose those DTCs first.

No comments:

Post a Comment