The actual value is okay.End of test
NO
The actual value is not o.k.Possible cause and remedy
- Check power supply of component B28 (Pressure sensor).
- Test signal voltage of component B28 (Pressure sensor).
Further possible causes of fault
- Vacuum line
2.2. Check power supply of component B28 (Pressure sensor).
Figure legend
- B28 (Pressure sensor)
- 126/1 -'Secondary air injection left bank of cylinders' shutoff valve
Test prerequisite
- The actual value is not o.k.
Test sequence
- Switch off ignition.
- Detach coupling at component B28 (Pressure sensor).
- Measure direct voltage with multimeter between sockets (B28) 1 and (B28) 3
- Switch on ignition.
Specified value
- Voltage[4.75...5.25] V
Question
- Is the measurement value OK?
YES
The measurement value is OK.Further possible causes of fault
- Test signal voltage of component B28 (Pressure sensor).
NO
The measurement value is not OK.Possible cause and remedy
- Lines to component N3/10 (ME-SFI [ME] control unit)
No comments:
Post a Comment