Saturday, August 7, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 642

2010 Cadillac Truck SRX FWD V6-3.0L Page 642



瀚慖f less than the specified range, test either control circuit for a short to ground. If the circuits test normal, replace the X53 fuse block-rear.



瀚慖f greater than the specified range, test either control circuit for a short to voltage or an open/high resistance. If the circuits test normal,



replace the X53 fuse block-rear.



11. If all circuits test normal, replace the K9 BCM.



Component Testing



1. Ignition OFF, disconnect the harness connector at the appropriate A23 door latch assembly.



2. Install a 25 A fused jumper wire between one of the control terminals and 12 V. Momentarily install a jumper wire between the other control



terminal and ground. Reverse the jumper wires at least two times, the A23 door latch assembly should perform the LOCK and UNLOCK



functions.



瀚慖f it does not perform as specified, replace the A23 door latch assembly.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Front Side Door Lock Replacement (See: Body and Frame/Locks/Door Locks/Service and Repair/Front Side Door Lock Replacement)



* Rear Side Door Lock Replacement (See: Body and Frame/Locks/Door Locks/Service and Repair/Rear Side Door Lock Replacement)



* Fuse Block Replacement (See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Service and Repair/Removal and Replacement/Fuse



Block Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming



B3140



DTC B3140 or B3150



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B3140 00



- Driver Unlock Switch Circuit



DTC B3150 00



- Driver Lock Switch Circuit



Diagnostic Fault Information



Circuit/System Description



The body control module (BCM) monitors the voltage level of the door lock and door unlock signal circuits. When the central door lock switch is



in the open position, the voltage level in the signal circuit will be near 0 V. When the central door lock switch is pressed to the lock or unlock



position, a signal will be sent to the BCM requesting a lock or unlock command.



Conditions for Running the DTC



The system voltage is 9-16 V.



Conditions for Setting the DTC

No comments:

Post a Comment