2010 Cadillac Truck SRX FWD V6-3.0L Page 448

2010 Cadillac Truck SRX FWD V6-3.0L Page 448

Steering Wheel Controls Description and Operation (See: Accessories and Optional Equipment/Description and Operation/Steering Wheel

Controls)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left.

2. Test for less than 10 ohm between the signal circuit terminal 2 and ground.

瀚慖f greater than the specified value, test the signal circuits for a short to voltage or an open/high resistance. If the circuit tests normal,

replace the K9 Body Control Module.

3. Ignition ON, test for greater than 11 V between the 12 V reference circuit terminal 1 and ground.

瀚慖f less than the specified value, test the 12 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,

replace the K9 Body Control Module.

4. Ignition OFF, disconnect the X3 harness connector at the K9 Body Control Module.

5. Test for infinite resistance between the signal circuit terminal 9 X3 and ground.

瀚慖f less than the specified value, test the signal circuit for a short to ground.

6. If all circuits test normal, test or replace the S70L Steering Wheel Controls Switch - Left.

Component Testing

Left Steering Wheel Switch Test

1. Disconnect the harness connector at the S70L Steering Wheel Controls Switch - Left.

2. Turn the cruise control switch in the ON position.

3. Test the resistance between the terminals 1 and 2.

瀚慖f any of the resistance measurements for the individual switches are not within the specified resistance values, replace the S70L Steering

Wheel Controls Switch - Left.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Radio Control Switch Replacement - Steering Wheel (See: Accessories and Optional Equipment/Radio, Stereo, and Compact

Disc/Radio/Stereo/Service and Repair/Radio Control Switch Replacement - Steering Wheel)

* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, setup, and programming

B1325

DTC B1325

Diagnostic Instructions