2010 Cadillac Truck SRX FWD V6-3.0L Page 440

2010 Cadillac Truck SRX FWD V6-3.0L Page 440

Conditions for Running the DTC

* Ignition in RUN or ACC position.

* The system voltage is at least 9.5 V and no more than 15.5 V.

Conditions for Setting the DTC

* The multimedia player interface module detects a short to battery on the signal circuit terminal 1 or signal circuit terminal 2.

* The multimedia player interface module detects a short to ground on the signal circuit terminal 1 or signal circuit terminal 2.

* All the above conditions are present for greater than 250 mS.

Action Taken When the DTC Sets

No audio is heard from the remote audio device.

Conditions for Clearing the DTC

* The conditions for setting the DTC are no longer present on the auxiliary input signal circuits.

* A history DTC clears after 50 malfunction-free ignition cycles.

Diagnostic Aids

* This DTC may be stored as a history DTC without affecting the operation of the module.

* If stored only as a history DTC and not retrieved as a current DTC, do not replace the module.

Reference Information

Schematic Reference

Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Radio/Audio System Description and Operation (See: Accessories and Optional Equipment/Description and Operation/Radio/Audio System)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the X1 harness connector at the auxiliary audio jack.

2. Ignition ON, test for less than 1 V between the terminals listed below and ground:

* signal terminal 1

* signal terminal 2

瀚慖f greater than the specified value, test the circuit for a short to voltage. If the circuit tests normal, replace the multimedia player interface

module.

3. Ignition OFF, test for infinite resistance between the terminals listed below and ground:

* signal terminal 1

* signal terminal 2

瀚慖f less than the specified value, test the circuit for a short to ground. If the circuit tests normal, replace the multimedia player interface