Wednesday, July 7, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 465

2010 Cadillac Truck SRX FWD V6-3.0L Page 465



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Front Object Alarm Sensor Replacement (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist



Systems/Parking Assist Distance Sensor/Service and Repair/Front Object Alarm Sensor Replacement)



* Rear Object Sensor Replacement (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Parking



Assist Distance Sensor/Service and Repair/Rear Object Sensor Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning)for parking assist control module replacement,



programming and setup



B1451



DTC B1451



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle)



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis)



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)



DTC Descriptors



DTC B1451 01



- Accessory Power Circuit Short to Voltage



DTC B1451 02



- Accessory Power Circuit Short to Ground



DTC B1451 04



- Accessory Power Circuit Open/High Resistance



Diagnostic Fault Information



Circuit/System Description



The keyless entry control module provides backup control for the accessory wake-up serial data circuit by applying voltage to the circuit. The



accessory wake-up serial data circuit is energized when the ignition mode switch is in ACC or RUN.



Conditions for Running the DTC



B1451 01, B1451 04



* Vehicle power mode is OFF or Crank Request



* Module is awake



* DTC B1451 not already set



* System voltage is 6-16 V



B1451 02



* Vehicle power mode is ACC or RUN



* Module is awake



* Output is active



* DTC B1451 is not already set



* System voltage is 6-16 V



Conditions for Setting the DTC



B1451 01



Accessory output is not active and a short to battery is detected 3 consecutive times.



B1451 02



Accessory output is active and a short to ground is detected 3 consecutive times.

No comments:

Post a Comment