Tuesday, July 27, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 690

2010 Cadillac Truck SRX FWD V6-3.0L Page 690



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay



Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power



Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, programming and setup



B3794



DTC B3794



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptors



DTC B3794 08



- Cruise Control Function Request Circuit Signal Invalid



DTC B3794 61



- Cruise Control Function Request Circuit Actuator Stuck



Diagnostic Fault Information



Circuit/System Description



The cruise control switch is an input to the body control module (BCM). The BCM monitors the cruise control on/off, set/coast, resume/accelerate



and cancel switches via the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function.



The BCM detects a specific voltage signal on the cruise control switch signal circuit when a switch is applied. The BCM sends a serial data



message to the engine control module (ECM) indicating the status of the cruise control switches.



Conditions for Running the DTC



* The cruise switch is ON.



* The ignition is ON.



Conditions for Setting the DTC



B3794 08



The BCM detects an invalid voltage signal on the cruise control switch signal circuit for 1 second.



B3794 61



Stuck switch for either Resume/Accel or Set/Coast button for 60 seconds.



Actions Taken When the DTC Sets



* The malfunction indicator lamp (MIL) will not illuminate.



* The cruise control system is disabled.



Conditions for Clearing the DTC



* The condition responsible for setting the DTC no longer exists.

No comments:

Post a Comment