Wednesday, July 7, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 387

2010 Cadillac Truck SRX FWD V6-3.0L Page 387



Circuit/System Description



The brake pedal position sensor is used to sense the action of the driver application of the brake pedal. The brake pedal position sensor provides an



analog voltage signal to the body control module (BCM). The BCM will apply battery voltage to the right, left and center stop lamp control circuits



and to the trailer brake control module if equipped.



Conditions for Running the DTC



When the brake pedal is applied.



Conditions for Setting the DTC



The trailer brake control module receives a serial data message from the BCM that the brakes have been applied, but the trailer brake control



module does not detect a signal voltage on the center high mounted stop lamp control circuit.



Action Taken When the DTC Sets



The brake lights on the trailer will be inoperative



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles.



Reference Information



Schematic Reference



Trailer Connector/Provision Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System



Diagram/Trailer Connector/Provision Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



Observe the function of the E6 center high mounted stop lamp while pressing and releasing the brake pedal. The E6 center high mounted stop lamp



should turn ON when the pedal is pressed and OFF when the pedal is released.



If the E6 center high mounted stop lamp is always ON or always OFF, refer to Stop Lamps Malfunction (See: Lighting and Horns/Testing and



Inspection/Symptom Related Diagnostic Procedures/Stop Lamps Malfunction)



If the E6 center high mounted stop lamp turns ON and OFF as commanded, perform the Circuit/System Testing.



Circuit/System Testing



1. Ignition OFF, disconnect the X1 harness connector at the K67 trailer brake control module.



2. Connect a test lamp between the signal circuit terminal 14 and ground.



3. Ignition ON, command the Center Brake Lamp ON and OFF with a scan tool. The test lamp should turn ON and OFF while changing

No comments:

Post a Comment