Wednesday, July 21, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 459

2010 Cadillac Truck SRX FWD V6-3.0L Page 459



B1405 07, B1529 07, or B257B 07



The BCM detects a voltage greater than 12.2 V on dimmer switch signal circuit.



Action Taken When the DTC Sets



The BCM will not dim or illuminate any LED backlighting supplied by the backlight lamp control circuits.



Conditions for Clearing the DTC



* The condition responsible for setting the DTC no longer exists.



* A history DTC will clear once 100 consecutive fault free ignition cycles have occurred.



Reference Information



Schematic Reference



* Interior Lights Dimming Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Interior Lights Dimming



Schematics)



* Steering Wheel Secondary/Configurable Control Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical



Diagrams/Steering Wheel Secondary/Configurable Control Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Interior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Interior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, headlamps ON, vary the interior backlight dimming from low to full bright by using the dimmer switch. The interior backlighting



should start dim and then become full bright.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the S30 headlamp switch.



2. Test for less that 10 Ohms between the ground circuit terminal 6 and ground.



瀚慖f greater than the specified range, test the ground circuit for an open high/resistance.



3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.



瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the K9 BCM.



4. Ignition ON, test for less than 0.3 V between signal circuit terminal 12 and ground.



瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.



5. Install a 3 A fused jumper wire between the signal circuit terminal 12 and the B+ circuit terminal 1. The interior backlighting should be



dimmed.



瀚慖f the interior backlighting is not dimmed, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests



normal, replace the K9 BCM.

No comments:

Post a Comment