Friday, July 2, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 2184

2010 Cadillac Truck SRX AWD V6-3.0L Page 2184



Note: Only the high speed GMLAN modules have a wired serial data wake up circuit. Refer to the module schematics to identify which



modules have a wake up circuit. If the module that is not communicating does not have a serial data wake up circuit, proceed to step 5.



4. Ignition ON, verify that a test lamp illuminates between the high speed GMLAN serial data wake up circuit OR the accessory wake up serial



data circuit and ground.



瀚慖f the test lamp does not illuminate, test the circuit for an open/high resistance. If the circuits test normal, replace the BCM.



5. Ignition ON, verify that a test lamp illuminates between all B+ circuits and ground.



瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit fuse is open, also test



the positive voltage outputs of the module for a short to ground. If the circuits test normal, replace the appropriate module.



6. Verify that a test lamp illuminates between all ignition voltage circuits and ground.



瀚慖f the test lamp does not illuminate, test the ignition voltage circuits for a short to ground or an open/high resistance. If the circuit fuse is



open, also test the positive voltage outputs of the module for a short to ground. If the circuits test normal, replace the appropriate module.



7. Test for less than 1 Ohms in the GMLAN serial data circuits between the non-communicating module and the module that displays the DTC.



瀚慖f greater than specified range, test the GMLAN serial data circuits for open/high resistance.



8. If all circuits test normal, replace the module that is not communicating.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* GMLAN Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Wiring Repairs/GMLAN Wiring Repairs)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, setup, and programming



Verification Tests



Diagnostic Repair Verification



1. Install any components or connectors that have been removed or replaced during diagnosis.



2. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.



3. Clear the DTCs.



4. Ignition OFF, all vehicle systems OFF, this may take up to 2 minutes.



5. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in



order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List -



Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) and perform the appropriate diagnostic



procedure.



Or



If the repair was symptom related, duplicate the conditions under which the customer concern occurred to verify the repair. If the customer



concern reoccurs or another symptom is present, return to Symptoms - Vehicle (See: Testing and Inspection/Symptom Related Diagnostic



Procedures/Symptoms - Vehicle) and perform the appropriate symptom diagnostic.

No comments:

Post a Comment