Friday, July 16, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 2158

2010 Cadillac Truck SRX AWD V6-3.0L Page 2158



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool References



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Engine running for 10 seconds.



2. Ignition ON, engine OFF, verify the DTC U0400-U05FF is not set.



瀚慖f the DTC U0400-U05FF is set along with other DTCs set, diagnose all other codes first. Refer to Diagnostic Trouble Code (DTC) List -



Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle).



瀚慖f the DTC U0400-U05FF is set without other DTCs set, program the control module specified by the DTC descriptor. If the DTC resets,



replace the appropriate control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup, and programming



U18B9



DTC U18B9-U18BF



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC U18B9



- Primary High Speed CAN Bus Subnet Configuration List



DTC U18BF



- Secondary High Speed CAN Bus Subnet Configuration List



Circuit/System Description



Control modules on the high speed GMLAN serial data bus and the chassis high speed GMLAN serial data bus must be programmed with software



that specifically identifies the correct type and quantity of modules on the bus based on RPO configuration. If a control module was not properly



configured after installation, the appropriate U Code may be set for that module. No external circuit diagnosis is involved.



Conditions for Running the DTC



* Voltage supplied to the module is in the normal operating voltage range.



* The vehicle power mode requires serial data communication to occur.



Conditions for Setting the DTC



* The control module is not configured properly.



* Control unit recognizes a programming error.



* CAN-Bus configuration is invalid



Conditions for Clearing the DTC



* A current DTC clears when the malfunction is no longer present.



* A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

No comments:

Post a Comment