Wednesday, July 14, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1777

2010 Cadillac Truck SRX AWD V6-3.0L Page 1777



DTC P0852



- Park/Neutral Position (PNP) Switch Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



The transmission manual shift shaft switch assembly, also known as the Internal Mode Switch (IMS), is a sliding contact switch attached to the



manual shift shaft inside the transmission case. The Park/Neutral Position (PNP) Switch is integrated into the IMS and connects to the Transmission



Control Module (TCM) lead-frame through a short wire harness. The circuit uses the TCM as a pass-through connector only. The Park/Neutral



Signal is sent from the park/neutral switch directly to the engine control module (ECM) and is used for engine start enable.



Conditions for Running the DTC



* Ignition voltage is between 8-18 volts.



* Engine speed is greater than 1000 RPM.



Conditions for Setting the DTC



P0850 and P0851



* The ECM detects the Park/Neutral switch signal equals 0 volts (Park/Neutral) when the IMS reports a Drive range for 0.2 second.



* TP is equal to or greater than 10 percent.



* Engine torque is equal to or greater than 75 Nm (55 lb ft).



* Vehicle speed is equal or greater than 10 km/h (6 mph).



P0852



The ECM detects the Park/Neutral switch signal equals 12 volts (In-Gear) when the IMS reports a Park/Neutral range for 0.2 second.



Action Taken When the DTC Sets



* DTCs P0850, P0851, and P0852 are Type C DTCs.



* The ECM uses IMS Range for engine start-up.



Conditions for Clearing the DTC



DTCs P0850, P0851, and P0852 are Type C DTCs.



Reference Information



Schematic Reference



Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)



Connector End View Reference



* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)



Description and Operation



Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -



Automatic Transmission/Electronic Component Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)

No comments:

Post a Comment