Monday, June 7, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 451

2010 Cadillac Truck SRX FWD V6-3.0L Page 451



* Terminal 1 X2, K84 Keyless entry control module



* Terminal 5 X2, K84 Keyless entry control module



* Terminal 16, A13 Rear audio control module



* Terminal 1 X4, K40 Seat memory control module



* Terminal 44 X1, A11 Radio



* Terminal 9 X1, K36 Inflatable restraint sensing and diagnostic module



* Terminal 17 X1, K36 Inflatable restraint sensing and diagnostic module



* Terminal 3, K60 Steering column lock control module



* Terminal 5, K60 Steering column lock control module



* Terminal 3 X2, K101 Trailer interface control module



* Terminal 1, K82 Module telephone control module



* Terminal 1 X1, T11 Multimedia player interface module



瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.



5. If the circuits test normal, replace the appropriate control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for the appropriate control module replacement, setup,



and programming



B1330



DTC B1330



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B1330 03



- Device Power 2 Circuit Voltage Below Threshold



Diagnostic Fault Information



Circuit/System Description



The keyless entry control module monitor the system voltage through the battery positive (B+) voltage circuits.



Conditions for Running the DTC



* The voltage supplied to the control modules is in the range of 7-26 V.



* The ignition is ON.



Conditions for Setting the DTC



B1330 03



The control module detects a system voltage less than 8.4 V for 5 seconds.



Action Taken When the DTC Sets



* The control module immediately disables all outputs when an out of range voltage condition has been detected, with the exception of serial



data, which is disabled after a 3 minute delay.



* The setting of other DTCs is inhibited.

No comments:

Post a Comment