Monday, June 21, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1611

2010 Cadillac Truck SRX AWD V6-3.0L Page 1611



Conditions for Running the DTC



* The ignition is in the START position.



* The system voltage is between 9.5-18 V.



Conditions for Setting the DTC



The ECM detects improper voltage on the control circuit of the starter relay.



Action Taken When the DTC Sets



DTC P0615, P0616, and P0617 are C type DTCs.



Conditions for Clearing the DTC



DTC P0615, P0616, and P0617 are C type DTCs.



Reference Information



Schematic Reference



Starting and Charging Schematics (See: Starting and Charging/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Starting System Description and Operation (See: Starting and Charging/Starting System/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Ignition OFF, disconnect the KR27 starter relay.



2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 10 Ohms between the relay



ground circuit terminal 85 and ground.



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



3. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 30 and ground.



瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.



瀚慖f the circuit tests normal and the B+ circuit fuse is open, test the control circuit terminal 87 for a short to ground.



4. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 87 and ground.



瀚慖f the test lamp illuminates, test the control circuit for a short to voltage.



5. Parking brake applied and the transmission is in NEUTRAL or PARK. Momentarily install a 30 A fused jumper wire between the B+ circuit



terminal 30 and the control circuit terminal 87. Verify the starter is activated.



瀚慖f the starter does not activate, test the control circuit for an open/high resistance. If the circuit tests normal, test or replace the starter.



6. Ignition OFF, connect a test lamp between the control circuit terminal 86 and the ground circuit terminal 85.

No comments:

Post a Comment