Sunday, June 27, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1664

2010 Cadillac Truck SRX AWD V6-3.0L Page 1664



瀚慖f not within the specified value, replace the K71 Transmission Control Module.



4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



瀚慖f the DTC resets, replace the K71 Transmission Control Module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup and programming.



P0708



DTC P0706-P0708



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0706



- Park/Neutral Position Switch Circuit



DTC P0707



- Park/Neutral Position Switch Circuit Low Voltage



DTC P0708



- Park/Neutral Position Switch Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Data



Circuit/System Description



Shift position switch function is installed as one part of transmission control module (TCM). The position switch consists of 2 switches, whose



values are running in the opposite direction. Automatic transmission shift range is calculated by TCM reading output voltage from gear lever



position sensor installed in TCM itself.



Conditions for Running the DTC



* Ignition voltage is 6-15.5 V.



* TCM is not in service mode.



Conditions for Setting the DTC



P0706



Sum of two position sensor voltage has deviation over 0.29 V from standard value 5 V.

No comments:

Post a Comment