Tuesday, May 25, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 654

2010 Cadillac Truck SRX FWD V6-3.0L Page 654



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Front Side Door Window Regulator Replacement (See: Windows and Glass/Windows/Service and Repair/Front Side Door Window



Regulator Replacement)



* Rear Side Door Window Regulator Motor Replacement (See: Windows and Glass/Windows/Service and Repair/Rear Side Door Window



Regulator Motor Replacement)



B3220



DTC B3205, B3210, B3215, or B3220



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B3205 00



- Driver Window Motor Circuit



DTC B3205 39



- Driver Window Motor Circuit internal electronic failure



DTC B3205 42



- Driver Window Motor Circuit calibration data set not programmed



DTC B3205 4B



- Driver Window Motor Circuit calibration not learned



DTC B3210 00



- Right Front/Passenger Window Motor Circuit



DTC B3210 39



- Right Front/Passenger Window Motor Circuit internal electronic failure



DTC B3210 42



- Right Front/Passenger Window Motor Circuit calibration data set not programmed



DTC B3210 4B



- Right Front/Passenger Window Motor Circuit calibration not learned



DTC B3215 39



- Left Rear Window Motor Circuit internal electronic failure



DTC B3220 39



- Right Rear Window Motor Circuit internal electronic failure



Circuit/System Description



When a window switch is pressed on the driver window switch, a serial data message is sent to the body control module (BCM). The BCM



examines the request and checks for messages from other power window motors prohibiting the window movement. If no prohibitive messages



have been received, the BCM will send a serial data message to the passenger window motor or to the appropriate rear window switch which will



perform the command as requested.



Conditions for Running the DTC



* The ignition switch is in the ON position



* Battery voltage must be between 9-16 V.



Conditions for Setting the DTC

No comments:

Post a Comment