Monday, May 17, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 66

2010 Cadillac Truck SRX FWD V6-3.0L Page 66



3. Ignition ON, verify the scan tool Deployment Loop Resistance parameter is greater than 5.12 ohm.



瀚慖f less than the specified range, test control circuit terminals for a short to ground. If the circuit tests normal, replace the K36 SDM.



4. Install a 3 A fused jumper wire between the following control circuit terminals. Verify the scan tool Deployment Loop Resistance parameter



is less than 1.8 ohm.



* circuit terminal 1 X1 and terminal 2 X1



* circuit terminal 4 X1 and terminal 3 X1



瀚慖f greater than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal,



replace the K36 SDM.



5. If all circuits test normal, test or replace the F107 driver steering wheel air bag.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Steering Wheel Inflatable Restraint Module Replacement (See: Restraints and Safety Systems/Air Bag Systems/Air Bag/Service and



Repair/Removal and Replacement/Steering Wheel Inflatable Restraint Module Replacement)



* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Wiring Repairs/SIR/SRS Wiring Repairs)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming



B0013



DTC B0012 or B0013



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category



DTC Descriptors



DTC B0012 01



- Driver Steering Wheel Air Bag Deployment Loop Stage 1 Short to Battery



DTC B0012 02



- Driver Steering Wheel Air Bag Deployment Loop Stage 1 Short to Ground



DTC B0012 04



- Driver Steering Wheel Air Bag Deployment Loop Stage 1 Open



DTC B0012 0D



- Driver Steering Wheel Air Bag Deployment Loop Stage 1 High Resistance



DTC B0012 0E



- Driver Steering Wheel Air Bag Deployment Loop Stage 1 Low Resistance



DTC B0013 01



- Driver Steering Wheel Air Bag Deployment Loop Stage 2 Short to Battery



DTC B0013 02



- Driver Steering Wheel Air Bag Deployment Loop Stage 2 Short to Ground



DTC B0013 04



- Driver Steering Wheel Air Bag Deployment Loop Stage 2 Open



DTC B0013 0D



- Driver Steering Wheel Air Bag Deployment Loop Stage 2 High Resistance



DTC B0013 0E



- Driver Steering Wheel Air Bag Deployment Loop Stage 2 Low Resistance

No comments:

Post a Comment