Thursday, May 13, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 520

2010 Cadillac Truck SRX FWD V6-3.0L Page 520



Conditions for Clearing the DTC



* The current DTC will clear and set the code to history 3 seconds after the reference voltage returns to the normal operating range and the



ignition is cycled OFF then back to ACC or RUN.



* The history DTC will clear after 40 consecutive fault-free ignition cycles have occurred.



Reference Information



Schematic Reference



Heated/Cooled Seat Schematics (See: Body and Frame/Seats/Seat Temperature Element/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Heated/Vented Seat Description and Operation (See: Body and Frame/Seats/Seat Temperature Element/Description and Operation/Heated/Vented



Seat)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Ignition OFF, disconnect the X2, X3 harness connectors at the K40 seat memory control module.



2. Test for greater than 3.0 kOhms between the signal and the low reference circuits listed below:



* E14B driver seat cushion terminal 16 X2 and terminal 12 X3



* E14D passenger seat cushion terminal 7 X2 and terminal 1 X3



瀚慖f less than the specified value, test for a short between the signal and low reference circuits. If the circuits test normal, replace the



appropriate E14 seat cushion heating element.



3. If all circuits test normal, replace the K40 seat memory control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Driver or Passenger Seat Cushion Heater Replacement (See: Body and Frame/Seats/Seat Temperature Element/Service and Repair/Driver or



Passenger Seat Cushion Heater Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for seat memory control module replacement, setup



and programming



Without Memory A45



DTC B2345 (Without Memory A45)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment