2010 Cadillac Truck SRX AWD V6-3.0L Page 2073
* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming
P2610
DTC P0601-P0604, P0606, P0607, P0610, P062B, P062F, P0630, P16F3, or P2610 (ECM, LF1/LFW/LWR)
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P0601
- Control Module Read Only Memory Performance
DTC P0602
- Control Module Not Programmed
DTC P0603
- Control Module Long Term Memory Reset
DTC P0604
- Control Module Random Access Memory Performance
DTC P0606
- Control Module Processor Performance
DTC P062B
- Control Module Fuel Injector Control Performance
DTC P062F
- Control Module Long Term Memory Performance
DTC P0630
- VIN Not Programmed or Mismatched - Engine Control Module (ECM)
DTC P16F3
- Control Module Redundant Memory Performance
DTC P2610
- Control Module Ignition Off Timer Performance
Circuit/System Description
This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if
the ECM is not programmed, or is programmed incorrectly.
Conditions for Running the DTC
P0601, P062B, P0630, P16F3
These DTCs run continuously when the ignition is ON.
P0602, P0603, P062F
These DTCs run at power up.
P0604
DTC P0604 runs continuously when the ignition is ON. First memory scan may take up to 30 s.
P0606
* System voltage is greater than 6 V.
* Reduced engine power is not active.
No comments:
Post a Comment