Saturday, May 15, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 178

2010 Cadillac CTS Sedan AWD V6-3.6L Page 178



Ignition ON, verify DTC B0099 is not set.



If DTC is set, replace the pedestrian impact detection module and the active hood hinge actuators.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Active Hood Hinge Actuator Replacement (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist



Systems/Service and Repair/Removal and Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for pedestrian impact detection module



replacement, setup, and programming



B101D



DTC B101D



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B101D XX



- ECU Hardware



Circuit/System Description



The internal fault detection is handled inside the control module. The symptom byte listed in the DTC Descriptor is for engineering reference only.



No external circuit diagnosis is involved.



Conditions for Running the DTC



The module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and ground. This



program runs even if the voltage is out of the valid operating range.



Conditions for Setting the DTC



The module has detected an internal malfunction.



Action Taken When the DTC Sets



The module refuses all additional inputs.



Conditions for Clearing the DTC



* A current DTC clears when the malfunction is no longer present.



* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.



Diagnostic Aids



* This DTC may be stored as a history DTC without affecting the operation of the control module.



* Do not replace a control module based only on DTC B101D being set in history with the exception of the following control modules:



- Sensing and Diagnostic Module (SDM)



- Passenger Presence System Module



* If DTC B101D is set as current, replace the appropriate control module.



Circuit/System Verification



Verify that DTC B101D is not set.

No comments:

Post a Comment